Yamaha IM8 General Specifications

IM8 Features  • Specifications  •  Block diagram • Dimensions • Panel Views • Brochure

 

IM8-40/IM8-32/IM8-24     MIN TYP MAX UNIT Frequency Response ST OUT, GROUP OUT, GAIN:min(CH INPUT *1, ST CH INPUT 1-4) 20Hz-20kHz,ref to the nominal output level @1kHz input:CH INPUT *1,ST CH INPUT 1-4,RETURN, 2TR IN -3.0 0.0 1.0 dB AUX SEND, MONITOR OUT,REC OUT Total Harmonic Distortion(THD+N) ST OUT +14dBu@20Hz-20kHz, GAIN:min     0.1 % Hum & Noise Hum & Noise are measured with a 6dB/octave filter @12.7kHz;equivalent to a 20kHz filter with infinite dB/octave attenuation. CH INPUT *1 EIN(Equivalent Input Noise) Rs=150Ω, GAIN:max     -128 dBu ST OUT GROUP OUT ST, GROUP Master fader at nominal level and all Ch assign SW's off.     -80 dBu AUX SEND AUX Master control at nominal level and all Ch mix controls at minimum.     -75 dBu ST OUT GROUP OUT ST,GROUP Master fader and one Ch fader at nominal level.     -64 dBu ST OUT Residual Output Noise     -98 dBu Crosstalk@1kHz adjacent input CH*1, GAIN:MIN     -70 dB   input to output ST OUT L/R, CH *1, PAN panned Hard left or right     -70 dB Maximum Voltage Gain @1kHz (all VR are MAX when measured) *PAN/BAL: panned hard left or hard right. Rs=150Ω,INPUT GAIN: maxCH INPUT*1 to CH INSERT OUT   60   dB CH DIRECT OUT   60   dB MASTER INSERT OUT (ST, GROUP, MONO)   70   dB ST OUT GROUP OUT   84   dB MATRIX OUT   94   dB REC OUT   62.2   dB MONO OUT   84   dB MONITOR OUT   80   dB PHONES OUT   79   dB AUX SEND, PRE   80   dB AUX SEND, POST   90   dB MASTER INSERT OUT (AUX), PRE   76   dB MASTER INSERT OUT (AUX), POST   66   dB Rs=150Ω,INPUT GAIN:maxST CH INPUT 1-4 LINE to ST OUT, GROUP OUT   58   dB AUX SEND, PRE   54   dB AUX SEND, POST   64   dB RETURN to ST OUT GROUP OUT   20   dB AUX SEND   26   dB 2TR IN to ST OUT   27.8   dB TALKBACK IN to ST OUT GROUP OUT AUX OUT   70   dB Input HPF CH *1 80Hz, 12dB/oct Input equalization (+15,-15dB maximum) Turn over/roll-off frequency of shelving: 3dB below maximum variable level. CH INPUT HIGH:10kHz: shelving Hi-MID:400-8kHz: peaking Lo-MID:80-1.6kHz: peaking LOW:100Hz: shelvin ST INPUT HIGH:10kHz: shelving Hi-MID:3kHz: peaking Lo-MID:800Hz: peaking LOW:100Hz: shelving LAMP IM8-40: 3pcs, IM8-32, IM8-24: 2pcs XLR-4-31 type, The LAMP voltage is 12V DC between 3pin and 4pin of XLR-4-31 connectors. Each lamp can use 5W max. Signal Indicator CH INPUT *1 ST CH INPUT 1-4 INSERT OUT signal 3 points LED meter (PEAK, 0, -20 dB) PEAK lights if the signal comes within 3dB of the clipping level. GROUP,AUX,MONO OUTPUTIndicator LED Level Meter Post ST Fader Pre MONITOR Level 4x12 points LED meter (PEAK,+10,+6,+3,0,-3,-6,-10,-15,-20,-25,-30 dB) USB Audio USB IN/OUT   Compressor (COMP) CH*1   Dimensions Height: 219mm(8.62), Depth: 739mm(29.1), Width: 1716mm(67.6) [40ch], 1471.5mm(57.9) [32ch], 1227mm(48.3) [24ch] Net Weight 51.5kg(113.5lbs) [40ch], 44.5kg(98.1lbs) [32ch], 37.5kg(82.7lbs) [24ch] Accessories Power Supply Cable(3m), USB Cable(1.5m), DVD-ROM (Cubase AI4) Options Power Supply: PW8, Gooseneck Lamp: LA5000, Power Supply Link Cable(1m): PSL1010 All fader are nominal when measured. (Nominal position is adjusted to a position that is 10dB lower than the maximum position) Output impedance of signal generator:150ohms *1 MH40:1-40, MH32:1-32, MH24:1-24   PW8       MIN TYP MAX UNIT Secondary Voltage +15V     +15   V -15V           V +12V         V +48V (Phantom Voltage), no load         V   less   more UNIT Abnormal Condition of Secondary Voltage +15V green LED:turn off +10   +21 V -15V green LED:turn off -21 -10 V +12V green LED:turn off +7.6 +18 V +48V (Phantom Voltage) green LED:turn off +32 — V Power Consumption 265W(40ch), 230W(32ch), 200W(24ch) Dimensions Height: 100.5mm (3.96), Depth: 412mm (16.2), Width: 480mm (18.9) Net Weight 11kg (24.3lbs)   ANALOG INPUT CHARACTERISTICS Input Terminals PAD GAIN Trim Actual Load Impedance For Use With Nominal Input level Connector   Sensitivity *2 Nominal Max. before clip CH IN A / 24ch:1-24 32ch:1-32 40ch:1-40 0 -60dB 3kΩ 50-600Ω Mics/Lines -80dBu (0.078mV) -60dBu(0.775mV) -40dBu (7.75mV) XLR-3-31 type *3 -16dB -36dBu (12.3mV) -16dBu (123mV) +4dBu (1.23V) 26dB -34dB -54dBu (1.55mV) -34dBu (15.5mV) -14dBu (155mV) +10dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V) CH IN B / 24ch:1-24 32ch:1-32 40ch:1-40 0 -60dB 10kΩ 600Ω Mics/Lines -80dBu (0.078mV) -60dBu (0.775mV) -40dBu (7.75mV) Phone Jack(TRS) *4 -16dB -36dBu (12.3mV) -16dBu (123mV) +4dBu (1.23V)) 26dB -34dB -54dBu (1.55mV) -34dBu (15.5mV) -14dBu (155mV) +10dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V) ST CH LINE IN 1-4 — -34dB 10kΩ 600Ω Lines -54dBu (1.55mV) -34dBu (15.5mV) -14dBu (155mV) Phone Jack *5 RCA PiN Jack +10dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V) CH INSERT IN /24ch:1-24 32ch:1-32 40ch:1-40 — — 10KΩ 600Ω Lines -20dBu (77.5mV) 0dBu (0.775V) +20dBu (7.75V) Phone Jack (TRS) *6 MASTER INSERT IN (AUX,GROUP, ST,MONO) — — 10KΩ 600Ω Lines -10dBu (77.5mV) 0dBu (0.775V) +10dBu (2.45V) Phone Jack (TRS) *6 RETURN [1-4] — — 10KΩ 600Ω Lines -12dBu (195mV) +4dBu (1.23 V) +24dBu (12.3V) Phone Jack *5 2TR IN [L,R] — — 10KΩ 600Ω Lines -26dBV (50.1mV) -10dBV (0.316V) +10dBV (3.16V) RCA Pin Jack 3.5 DIA Stereo Phone Jack TB IN — — 10KΩ 600Ω Lines -66dBu (0.389mV) -50dBu (2.45mV) -30dBu (24.5mV) XLR-3-31 type *7   ANALOG OUTPUT CHARACTERISTICS Output Terminals Actual Load Impedance For Use With Nominal Output level Connector Nominal Max. before clip STEREO OUT [L,R] 75Ω 600Ω Lines +4dBu (1.23 V) +24dBu (12.3V) XLR-3-32 type *2 GROUP OUT (1-8) 150Ω 10kΩ Lines +4dBu (1.23 V) +20dBu (7.75V) Phone Jack *3 AUX SEND (1-8) 75Ω 600Ω Lines +4dBu (1.23 V) +24dBu (12.3V) XLR-3-32 type *2 MATRIX OUT (1-8) 150Ω 10kΩ Lines +4dBu (1.23 V) +20dBu (7.75V) Phone Jack *3 MONO OUT 75Ω 600Ω Lines +4dBu (1.23 V) +24dBu (12.3V) XLR-3-32 type *2 CH INSERT OUT (MONO CH) 150Ω 10kΩ Lines 0dBu (0.775V) +20dBu (7.75V) Phone Jack *4 MASTER INSERT OUT (AUX,GROUP,ST,MONO) 150Ω 10kΩ Lines 0dBu (0.775V) +20dBu (7.75V) Phone Jack *4 DIRECT OUT (MONO CH) 150Ω 10kΩ Lines 0dBu (0.775V) +20dBu (7.75V) Phone Jack *3 REC OUT [L, R] 600Ω 10kΩ Lines -10dBV (0.316V) +10dBV (3.16V) RCA Pin Jack MONITOR OUT [L, R] 150Ω 10kΩ Lines +4dBu (1.23 V) +20dBu (7.75V) Phone Jack *3 PHONES OUT 100Ω 40Ω Phones 3mW 75mW Stereo Phone Jack   DIGITAL INPUT/OUTPUT CHARACTERISTICS Terminal Format Data length Connector USB USB AUDIO 1.1 16 bit USB B type